Fabric Basket

 

I found this fabric basket tutorial (courtesy of vlijtig) a couple of weeks ago and have been saving it for when I needed a simple but effective project. Tonight I carved out some time and completed one of these in less than an hour.  That time included doing some calculations to convert metric to inches, plus taking a phone call from my mother.  You can probably complete yours in about 30 minutes if you have all your materials ready to go ahead of time, and if you don’t forget to do things like attaching the interfacing before you sew up the lining.  Not that I ever do stuff like that (actually, yes, all the time). I’m blaming that on my heavily medicated condition at the moment, which is a result of refusing to seek medical attention when I knew I was too sick to get well on my own.

The tutorial measurements are metric, so I converted them to inches (sort of) before cutting my fabrics.  Since it’s hard to measure decimals on the typical U.S. ruler, I adjusted the measurements a little bit.  I cut my pieces as follows:

Fabric A: 8-3/4″ x 2-1/2″ (2 pieces)
Fabric B: 8-3/4″ x 7-7/8″
Fabric C: 8-3/4″ x 11-7/8″
Interfacing: 8-3/4″ x 11-7/8″

Instead of ribbon I made tabs out of fabric, finished to 1″ wide.

And here’s a photo of what I’m really using this basket for – to organize the pharmaceutical chaos on my desk.  You didn’t really think I have baskets of pretty thread sitting around on my sewing table, did you?